ATS service

ATS maintenance with thermal imaging diagnostics

ATS maintenance must follow the specified schedule and procedures. Effective servicing starts with diagnostics: inspection, operating mode checks and FLUKE thermal imaging, followed by targeted maintenance or preventive repairs, rather than indiscriminately tightening every connection.

The purpose of servicing is to find weak points before a failure: a hot terminal, poor contact, overloaded circuit or a problem with an interlock, controller or power transfer switch.

Comparison of thermal and visible-light images of an ATS power switching assembly
Diagnostics under actual load. A thermal camera identifies where losses occur: a contact, terminal, busbar or cable connection that is already heating up.
Our service approach

Assess the condition first, then perform maintenance

Scheduled maintenanceInspection, cleaning and checks of connections, labels, indication, controller, interlocks and manual operation at the specified service intervals.
FLUKE thermal imaging diagnosticsLocating hot spots at power contacts, busbars, terminals and cable entries to guide repairs.
Preventive repairsReplacement or restoration of components where an actual risk exists: overheating, poor contact, wear, a logic error or unstable operation.
Routine maintenance without diagnostics is like listening to an engine through a wall. You can make an educated guess, but measurement reveals the actual condition.
Thermal imaging inspection

Thermal imaging reveals problems before they become visible

While the ATS operates under load, we inspect the thermal pattern of the power circuits. Terminal or contact overheating often develops before any smell, insulation discolouration or protective trip.

  • inspection of power contacts, busbars and cable lugs;
  • comparison between phases and equivalent circuits;
  • identification of local hot spots rather than the cabinet’s average temperature;
  • recommendations for maintenance, tightening, cleaning, component replacement or retrofit.
Thermal imaging inspection of ATS cable connections
Local overheating at a connection indicates that the contact needs inspection.
ATS thermal imaging inspection
Temperature differences between phases indicate where to investigate.
Thermal imaging of busbars and cables
Inspection of busbars, flexible connections and cable routes.
Thermal imaging inspection of an ATS cabinet
Comparison of areas without overheating and potential trouble spots.
What we inspect

ATS servicing covers more than power contacts

Power switching sectionContacts, terminals, busbars, cable lugs, signs of overheating and the switch’s mechanical condition.
ControlController, relays, control power supply, status signals, alarm messages and event log.
InterlocksElectrical and mechanical interlocks, backfeed prevention and the retransfer logic for the normal source.
Manual modeClear transfer procedures, instructions on the cabinet door and accessible, safe service controls.
Maintenance bypassIf fitted, we inspect its condition and operating procedure. If absent, we assess whether adding one is appropriate.
Protection and monitoringSPD, multifunction meters, power analyser, RS485/Ethernet and volt-free contacts for supervisory monitoring.
Work sequence

Effective maintenance follows a clear sequence

Inspection and diagnosticsPhotographic records, documentation review, thermal imaging and identification of visible and hidden risks.
Scheduled maintenanceCleaning and checks of contacts, terminals, labels, indication, mechanisms and controls.
Functional testingVerification of ATS operating modes, interlocks, signals, manual operation and retransfer to the normal source.
FindingsWhat is serviceable, what needs repair, what should be upgraded and what should be taken out of service.
When to request service

Scheduled servicing helps prevent unexpected failures

Scheduled maintenanceBefore periods of high load or according to the facility’s maintenance schedule.
After an incidentVoltage dip, failed transfer, generator operation, smell, overheating or controller error.
Before changing the circuitAdding a generator, UPS, BESS, solar PV, bus sections or new supply priorities.